|
|
 |
|
Panasonic Time
Change For KX-TD Product Line |
|
|
|
|
Panasonic Time Change
(To Get This Document
In PDF)
This procedure is to be done from a display
phone at ext. number 101 or from a
designated manager extension. The first step
is to put that extension into a “user
programming” mode.
Notes about
programming mode:
- When in ‘programming’ mode some of the
phone buttons have different functions
- On a digital display
phone, there are three buttons located under
the display.
- When in
‘programming’ mode, the display shows labels
for these buttons for the main functions
needed, for example “->”, NEXT, or SEL
(select).
- If you get mixed up,
or when finished, get out of programming
mode by picking up the handset
and hanging it up again.
- Some phones have a
‘Program’ button in the upper left, some
have it on the bottom row above
the number 3, -if the phone does not have
one, then use the button labeled ‘Pause’.
- If you wait too long
between pressing buttons, the system may
cancel programming mode and
you will have to start all over
From Ext. 101:
1) Press PROGRAM
button
2) Press **1234
3) Display reads <USER-PGM NO?>
4) Dial 0 0 0 (three zeros, not the letter
O)
5) Display reads <Day/Time Set>
6) Press NEXT (same as SPKR PHN)
7) Display now shows date (if you need to
change the date, see steps 10 thru 15 below)
8) Press NEXT (SPKR PHN) again
9) Display now should show time (example
12:00 AM)
10) Enter the hour on your keypad (to change
current entry press CLEAR, or the TRANSFER
button)
11) Press -> (or FWD/DND button)
12) Enter the minutes
13) Press -> (or FWD/DND button)
14) Press SELECT (or AUTOANSWER/MUTE button)
to change AM or PM
15) Press STORE (or AUTODIAL/STORE) ***Don’t
Forget This Step***
16) Press END (or HOLD button)
17) Press SPKR PHN button or pick up handset
and hang up to exit programming mode.
|
|
|
|
|
|
1
Lesson
|
|
|
|
|